Breckwell W3000 Manuel d'utilisateur télécharger pdf (Page 9)

SPECIAL MOBILE / MANUFACTURED HOME

REQUIREMENTS

WARNING: Do not install in a sleeping room.

For installation in a mobile/manufactured home, the

outside air kit must be used.

(See “OUTSIDE AIR KIT – W3000FS ONLY”)

The W3000FS must be securely fastened to the floor

of the mobile (manufactured) home using the

mounting bolt holes located in the pedestal of the

W3000FS. Use only the holes provided.

If the optional blower is used the W3000FS must be

grounded to the steel chassis of the home with 8 Ga.

Copper wire using a serrated or star washer to

penetrate paint or protective coating to ensure

grounding.

WARNING: DURING THE INSTALLATION OF THIS

STOVE, DO NOT COMPROMISE THE

STRUCTUARL INTEGRITY OF THE MOBILE

(MANUFACTURED) HOME WALL(S), FLOOR OR

CEILING.

INSTALLING THE BRICK PANELS

The brick panels will come already installed in the

W3000. The following directions are included should

you ever need to remove and re-install the brick

panels.

Wearing gloves is recommended when handling the

brick panels.

Install the brick panels shown in figure 6 in the

following order: C, A (rear), D, A (bottom). Next install

the ‘B’ panels on the secondary tubes.

(See figures 7 & 8)

INSTALLATION

FIGURE 6

FIGURE 7

FIGURE 8

BRICK SIZES

A = 10” x 12”

B = 9-3/4” x 15-1/4”

C = 9” x 7-7/8”

D =

7/8” x 2

0”

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Breckwell W3000 Manuel d'utilisateur Page 9